New Installation Tester According To VDE 0100 By Megger

The new MFT1835 with type B inspection of Megger the currently lightest installation testers on the market MFT1835, for example, only two lines (!) phase and require protection. The neutral conductor is no longer necessary! So, now has only one hand at the probe tip of the test engineers and checks through very quickly and also still much safer as the Cabinet without settling on a train. A further high-light: DIN VDE 0100 installation Tester MFT1835 is also multipolar ground Tester, where even two optional Erdungsprufzangen can easily be connected. Each Earth finish now dispenses with the disconnection and can be checked out in a few seconds. Even here, the Pruftechiker is protected, because here the installation tester must not necessarily be touched! This greatly accelerated the testing and protects even by accidental contact with live parts. The test engineers have finally dealt with fewer cables and connectors.

The third plus: the Smart”fuse protection the usual breaking of the circuit continuity or insulation measurements avoids inadvertently coming contact with live wires in contact. The installation tester of mft1835 of Megger instead emits a very clearly visible warning signal. Expensive and inconvenient power outages due to erroneous contact are past. Even more protection provides the interpretation of course up to 300 volts in a CATIV environment also at the main terminals outside the building or in an industrial environment.