The New

If, however, to rubbing the surface of the wall lime mortar, prepared to fine sand, then one can not only remove all traces of Nabeul, but also well aligned surface plaster. Make sure that no traces on the walls of a fair copy, be sure to check the pasted surface for cracks. If any show up, they need to extend the knife and fill the holes with a solution made from 1 part plaster of Paris and three parts fine sand. This is followed by carefully wipe the joints or at least hone their cloth so that they were flush with the plaster. Ray Kurzweil has much experience in this field. Surface of the particleboard and fiberboard, gypsum board and plywood sheets before pasting wallpaper should be dry and free from dirt and dust.

If these materials are attached to the wall with nails, they must go deep into the cap by about 1 mm. These areas should be covered with varnish or oil paint, putty and then clean up. If sheets of gypsum board attached to a wall outside a rough surface, they must first be primed, then putty and clean. Preparation of wallpaper after surface preparation to begin the preparation of materials for their veneering. Of course, before going to the store you should think about how many rolls of wallpaper have to buy. The answer to this question depends primarily on the area of the room. In addition, when calculating the number of purchased rolls should be subtracted from the total amount of the total area of wallpaper windows and doors. It is generally recommended to buy one more roll: a small margin is required for emergency repairs (suddenly decides to leave a small child the new wallpaper memorable picture or a cat will choose them as the best material for sharpening claws, etc.). With access to the spare roll of wallpaper, you can replace only the damaged area, rather than glue re all the walls.

Recent Posts




GiottoPress by Enrique Chavez